CE-676-2
DIGITAL
DOOR
RECEIVER
Installation Instructions
Description
The MegaCode series of digital receivers are wireless radio controls designed
for use with automatic door operators. The MegaCode radio format provides
unparalleled security.
MegaCode receivers and transmitters do not contain a typical “coding switch”. Each
transmitter is pre-set at the factory to a unique code. The receiver is programmed
by sending a signal to it from the transmitter(s) that are going to be used with it.
This stores the transmitters code into the receiver’s memory. The receiver will
retain its memory even without power. The receiver will activate only from these
“memorized” transmitters.
Each MegaCode receiver can remember a maximum
of 40 transmitters.
The receivers can operate from 12-30 volts AC or 10.5-30 volts DC and are normally
powered from the door operator. The relay contact(s) are rated at 5 amps @ 32 volts
AC/DC NEC Class 2 circuit.
The CE-676-2 series has an “F” connector for attaching an antenna. The receiver
is supplied with a 9-inch local antenna, a three foot 75 ohm coaxial cable, and a
bulkhead connector for mounting the antenna outside the door operator enclosure
STEP 1
Connect receiver relay output
Connect the appropriate wires (GREEN), (WHITE) to the appropriate activation
terminals on the door operator.
STEP 2
Connect receiver to power
Connect the (RED) input wire to the AC or DC+ and the (BLACK) wire to the AC or
DC- terminal on the door operator.
STEP 3
Mount the receiver
Use the screws provided to mount the receiver within the operator housing. This
provides protection from the elements. Secure case with case screws.
STEP 4
Connect antenna
Connect the coaxial cable to the “F” connector on the receiver. Drill a 3/8” hole on
the top of the operator housing for the bulkhead connector. Insert the connector and
secure it with the nut and lock washer. Connect the cable and antenna to the bulkhead
connector.
STEP 5
Open receiver case
To open the receiver case, remove the screws, squeeze sides of case and rotate
upward.
STEP 6
CE-676-2 code switch
The pushbutton labeled S1 is used to program transmitters.
28727 Industry Dr, Valencia, CA 91355
(800) 643-6353 Fax 818-782-5979
www.curranengineering.com
RECEIVER
LOCAL
ANTENNA
BULKHEAD
CONNECTOR
3-FOOT
CABLE
CASE SCREWS
MOUNTING
HARDWARE
WASHER
NUT
MOUNT RECEIVER
INSIDE GATE
HOUSING
SECURE CASE
CLOSED WITH TWO
SCREWS AT BOTTOM
OF CASE
CONNECT COAXIAL
CABLE TO "F"
CONNECTOR
SLIDE WEATHER
RESISTANT CAP
OVER CONNECTION
INSERT BULKHEAD
CONNECTOR THROUGH
OPERATOR HOUSING
SECURE CONNECTOR
TO HOUSING USING
WASHER AND NUT
CONNECT CABLE TO
BULKHEAD CONNECTOR
SQUEEZE BOTH SIDES AT TABS
AND TILT UPWARD
S1
S1
SINGLE CHANNEL
PUSHBUTTON
USE THIS
PUSHBUTTON
TO ENTER
TRANSMITTERS
PRINTERS INSTR
UCTIONS
INSTR,INSTL,MEGA RCVR,CE-676-2,OEM - P/N:
225821 AX4 - INK:
BLA
CK - MA
TERIAL:
20 LB
. MEAD BOND - SIZE:
8.500”
X 11.000”
- SC
ALE:
1-1 - SIDE 1 of 2