EN
42
Problem
Possible cause
Action
The product will not start. No power.
Check mains voltage, power point,
plug and power cord.
Tripped fuse.
Check, and if necessary replace.
Defective power switch.
Check, and if necessary replace.
Carbon brushes in motor
worn.
Check, and if necessary replace.
Defective motor.
Check, and if necessary replace.
Damaged power cord.
Check, and if necessary replace.
Safety switch not engaged.
Check that the dust extraction funnel
is correctly fitted.
The motor speed drops.
Planing depth too deep.
Adjust the depth.
The workpiece is fed too
quickly.
Feed more slowly.
Blunt planer head.
Replace planer head.
The motor stops.
No power.
Check mains voltage, power point,
plug and power cord.
Defective motor.
Check, and if necessary replace.
Defective power switch.
Check, and if necessary replace.
Rough surface on
workpiece.
Blunt or damaged planer
head.
Check, and if necessary replace.
Uneven feeding.
Make sure that the workpiece is fed
smoothly.
Feeding too fast.
Feed more slowly.
The dust ejection port
clogs up during the work.
Planing depth too deep.
Adjust the depth.
The workpiece is too damp.
Wait until the workpiece has dried.
Summary of Contents for 020962
