Medrad Mark 7 Arterion, Operation Manual

Page: 115 / 162

Installation - System and Accessory
16 - 107
Figure 16 - 32: Hand Switch Display Control Unit Location
Figure 16 - 33: Use Clip to Attach Hand Switch Cable to the Display Control Unit
16.6.4 Hand Switch Mount Kit
The hand switch mount kit contains hardware to allow the operator to mount the hand switch to any
flat surface (such as the back of the Display Control Unit) and onto a pole or similarly shaped object.
1.
To mount using the metal bracket and double-sided tape,
a.
Attach the hand switch holster (A) to the metal bracket using the included screws.
Figure 16 - 34: Hand Switch Holster with Bracket
b.
Using the supplied alcohol wipe, thoroughly clean an area on the mounting surface
approximately the shape and size of the pre-cut double-sided tape.
c.
Apply a thin film of the included surface primer to the area (B) where it will be mounted
and to the metal bracket.