Medisafe SI PCF, User Manual

Page: 27 / 81

Installation SI PCF User Manual
Ref: DOC03148 Issue 1 Friday, 06 January 2017
Page 27 of 81
Water Supply
Water Hardness
(CaCO
3
), Quality & Purity
<125ppm with water quality and purity tested and approved for Disinfection as per
EN ISO15883-1:2009 (
item 6.4.1 and 6.4.2 )
Pressure 2 – 5 bar ( 30 – 70 psi ) for all water supplies
Flow Rate 12 – 30 l/m ( 3 – 8 US gal/m )
Temperature:
Cold Water 5 – 30°C (41 – 86°F )
Hot Water 50 – 80°C (
122 – 140°F
)
RO Water 5 – 80°C ( 41 – 140°F )
Connection
1x shut valve with ¾in BSP male thread for hose tail ( Hot water )
1x shut valve with ¾in BSP male thread for hose tail ( Cold water )
1x shut valve with ¾in BSP male thread for hose tail ( RO water )
Position Within 1m ( 40in ) of proposed installation
Drainage System
Type Pumped
Drain Connection
19mm (¾i n ) hose tail outlet from machine
Drain must fitted with suitable traps
No Loops in the drain hose, cut the hose to required length
Position
Drain entry and the entire drain hose must less than 500mm (20in) above ground
level sited at the rear middle of the machine
Drain gulley pipe ID must be at least 100mm (
4in ) to conform with ISO15883
Capacity > 30ltr/m ( 8 US gal/m )
Overflow
48.3mm ( 1.9in ) OD outlet from machine – into the same gulley as the drain
The overflow hose connection to the main drainage system must not be airtight
Effluent Temp 95°C (203 °F )
Printer
Dimensions W:230mm ( 9in ) x D:280mm ( 11in )
Position
Above or to the side and at least within 1m ( 40in ) from the machine, where it will not
be affected by spillage, leakage or condensation from the equipment
Supply Connection
90 - 230Vac 50/60Hz ( single phase )
Position of printer
power supply Within 1m ( 40in ) from the machine, where it will not be affected by spillage, leakage
or condensation from the equipment