Medias Mediatrix 1204, Reference Manual

Page: 59 / 390

Admin Page Reference Manual (SIP Version)
Mediatrix 1204 33
Case #3
You are performing a factory reset.
System Management
The following are the system management parameters you can set. These parameters apply to the whole
Mediatrix 1204.
You can also set these parameters via SNMP, as described in “Chapter 7 - MIB Structure and SNMP” on
page 103 .
X
To set the system management parameters:
1. In the System Management section of the Admin page, define the SNMP service agent status in the
SNMP Agent Activation choices.
The SNMP service agent controls whether the Mediatrix 1204 may be accessed via SNMP or not.
• Enable: SNMP connections are allowed.
• Disable: SNMP connections are forbidden.
If you are exclusively using the web page to configure the Mediatrix 1204, you could disable the
SNMP service agent and forbid any SNMP connection to the unit.
If the SNMP agent is disabled and the unit enters into recovery mode, SNMP connections are
allowed during that time. Once the unit returns to its normal state, the SNMP service agent will revert
to the configuration you have set.
Figure 13: Management – System Management Web Page
2. Select the proper command to execute in the System Command drop-down menu.
This command controls the various commands that can be performed by the unit.
Table 21: Case 3 Issue
Item Description
Wanted Behaviour The password to use is the default password in the profile.
Current Behaviour The password to use is the same as the one used in the older software version.
Workaround Once using the new software version, use the httpServerResetToDefaultPwd variable
as described in “Default User Name and Password” on page 32 .
Table 22: System Commands
Command Description
noOp No action is taken.
checkRam Launches the RAM check routine.
checkRom Currently unused.
downloadSoftware Launches a firmware update. See “Firmware Download” on page 53
for more details.
resetStats Resets all cumulated call statistics.
setConfigSourcesStatic Sets all configuration sources supported by the unit to “static”. This
command can be used when no DHCP server is present in the network
to easily configure the unit to use static values.
1
2