Medias Mediatrix 1204, Reference Manual

Page: 34 / 390

Chapter 1 - Installation Choosing a Suitable Installation Site
8 Mediatrix 1204
Choosing a Suitable Installation Site
The Mediatrix 1204 is suited for use in an office environment where it can be wall-mounted, mounted on a
standard 48.26 cm (19 in.) equipment rack, or free standing on its rubber feet. In addition, the Mediatrix 1204
can be rack-mounted in a wiring closet or equipment room.
Location
Install the Mediatrix 1204 in a well-ventilated location where it will not be exposed to high temperature or
humidity. Do not install the Mediatrix 1204 in a location exposed to direct sunlight or near stoves or radiators.
Excessive heat could damage the internal components.
When deciding where to position the Mediatrix 1204, ensure that:
The Mediatrix 1204 is accessible and cables can be easily connected.
The cabling is away from the following:
• Sources of electrical noise such as radios, transmitters, and broadband amplifiers.
• Power lines and fluorescent lighting fixtures.
• Water or moisture that could enter the casing of the Mediatrix 1204.
The airflow is not restricted around the Mediatrix 1204 or through the vents in the side of the
unit. The unit requires a minimum of 25 mm (1 in.) clearance.
No more than four Mediatrix 1204 units are placed on top of one another, if the units are free
standing.
The operating temperature is between 0
o
C and 40
o
C.
The humidity is not over 85% and is non-condensing.
Warning:
The analog lines of the Mediatrix 1204 are not intended for connection to a telecommunication
network that uses outside cable.
Warning:
To prevent fire or shock hazard do not expose the unit to rain or moisture.
Note:
The wall-mounting or rack-mounting kit is not part of the standard package and must be ordered
separately.