Medias Mediatrix 1204, Reference Manual

Page: 23 / 390

Document Conventions Reference Manual (SIP Version)
Mediatrix 1204 xxiii
Document Conventions
The following information provides an explanation of the symbols that appear on the Mediatrix 1204 and in the
documentation for the product.
Warning Definition
Where to find Translated Warning Definition
For safety and warning information, see “Appendix A - Standards Compliance and Safety Information” on
page 295.
This Appendix describes the international agency compliance and safety information for the Mediatrix 1204. It
also includes a translation of the safety warning listed in the previous section.
Other Conventions
The following are other conventions you will encounter in this manual.
SCN vs PSTN
In Mediatrix’ and other vendor’s documentation, the terms SCN and PSTN are used. A SCN (Switched Circuit
Network) is a general term to designate a communication network in which any user may be connected to any
other user through the use of message, circuit, or packet switching and control devices. The Public Switched
Telephone Network (PSTN) or a Private Branch eXchange (PBX) are examples of SCNs.
Standards Supported
When available, this document lists the standards onto which features are based. These standards may be
RFCs (Request for Comments), Internet-Drafts, or other standard documents.
The Mediatrix 1204’s implementations are based on the standards, so it’s possible that some behaviour differs
from the official standards.
For more information on and a list of RFCs and Internet-Drafts, refer to the IETF web site at http://www.ietf.org .
Warning:
Means danger. You are in a situation that could cause bodily injury. Before you work on any
equipment, you must be aware of the hazards involved with electrical circuitry and be familiar with standard
practices for preventing accidents.
Caution:
Caution indicates a potentially hazardous situation which, if not avoided, may result in minor or
moderate injury and/or damage to the equipment or property.
Note:
Note indicates important information about the current topic.
Standards Supported Indicates which RFC, Draft or other standard document is supported for a
specific feature.
This symbol indicates you can also set the current configuration by using the Unit Manager Network Graphical
User Interface. The text will provide the location in the
Unit Manager Network Administration Manual where to
find information related to the specific configuration.