Media5 Mediatrix C710, Hardware Installation Manual

Page: 39 / 52

Safety Recommendations Hardware Installation Guide
Mediatrix C7 Series – Digital Gateway 27
Circuit Breaker (15A) Warning
TN Power Warning
Product Disposal Warning
No. 26 AWG Warning
ETH2, ETH1, and FXS Connectors Warning
Socket Outlet Warning
Safety Recommendations
To insure general safety follow these guidelines:

Do not open or disassemble this product.

Do not get this product wet or pour liquids into it.

Do not perform any action that creates a potential hazard to people or makes the equipment
Warning:
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure
that a fuse or circuit breaker no larger than 120 VAC, 15A U.S. (240 VAC, 10A international) is used on the
phase conductors (all current-carrying conductors).
Warning:
The device is designed to work with TN power systems.
Warning:
Ultimate disposal of this product should be handled according to all national laws and
regulations.
Warning:
To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.
Warning:
Do not connect the ETH2 , ETH1 , and FXS connectors directly to the Public Switched Telephone
Network (PSTN), to an off premise application, an out of plant application, any exposed plant application, or
to any equipment other than the intended application, connection may result in a safety hazard, and/or
defective operation and/or equipment damage.
Exposed plant means where any portion of the circuit is subject to accidental contact with electric lighting or
power conductors operating at a voltage exceeding 300V between conductors or is subject to lightning
strikes.
Warning:
The socket outlet, if used, shall be located near the equipment and shall be easily accessible by
the user.The AC adaptor inlet is considered as disconnection device. The device must be readily
operational.