Media5 Mediatrix C710, Hardware Installation Manual

Page: 32 / 52

Chapter 3 - Powering on the Mediatrix C7 Series Management Choices
20 Mediatrix C7 Series – Digital Gateway

To trigger the Factory Reset:
1. Power the Mediatrix C7 Series off.
2. Insert a small, unbent paper clip into the Reset / Default hole located at the rear of the Mediatrix
C7 Series. While pressing the Reset / Default button, restart the unit.
Do not depress before the LEDs stop blinking and are steadily ON.
3. Release the paper clip.
The Mediatrix C7 Series restarts.
This procedure resets all variables in the MIB modules to their default value.
When the Mediatrix C7 Series has finished its provisioning sequence, it is ready to be used with a
DHCP-provided IP address and MIB parameters.
This procedure can also be performed at run-time.
Management Choices
Congratulations for properly installing the Mediatrix C7 Series. You can now configure the software
parameters of the unit.
The Mediatrix C7 Series offers various management options. All these options are described in the
Dgw v2.0
Software Configuration Guide .
Note:
The Factory reset alters any persistent configuration data of the Mediatrix C7 Series.
Table 9: Management Options
Management Choice Features
Web GUI The Mediatrix C7 Series web interface allows you to configure the following
information:
• Network attributes
• SIP parameters
• VoIP settings
• Management settings such as configuration scripts, restore / backup,
etc.
SNMPv1/2/3 The Mediatrix C7 Series SNMP feature allows you to configure all the MIB
services.
Command Line
Interface (CLI) The Mediatrix C7 Series CLI feature allows you to configure all the MIB services.
Unit Manager
Network The UMN offers the following:
• Auto-discovery
• Group provisioning
• SNMP access and remote management.