Media5 Mediatrix C710, Hardware Installation Manual

Page: 30 / 52

Chapter 3 - Powering on the Mediatrix C7 Series RESET/DEFAULT Button
18 Mediatrix C7 Series – Digital Gateway
RESET/DEFAULT Button
The RESET/DEFAULT button allows you to:

Cancel an action that was started.

Revert to known factory settings if the Mediatrix C7 Series refuses to work properly for any
reason or the connection to the network is lost.

Reconfigure a unit.
At Run-Time
The RESET/DEFAULT button can be used at run-time – you can press the button while the Mediatrix C7
Series is running without powering the unit off. Table 8 describes the actions you can perform in this case.
In Use
Lines Idle and Unlocked Steady OFF
Lines InUse and Unlocked Steady ON
Shutting Down Steady yellow
Locked Blinking yellow, 1 Hz, 50% duty
Ready
All lines are enabled
(operational state). Steady ON
All lines are disabled
(operational state). Steady OFF
At least one line is enabled
and at least one line is
disabled (operational state). Blink 0.25 Hz 75%
Table 7: Default LED Behaviour (Continued)
LED Type Condition Behaviour
Table 8: RESET/DEFAULT Button Interaction
RESET/
DEFAULT Button
Pressed for:
Action Comments LEDs Pattern
2 to 6 seconds Restarts the
Mediatrix C7 Series No changes are made to the
Mediatrix C7 Series settings. Power LED:
• blinking, 1Hz,
50% duty
All other LEDs:
• OFF
7 to 11 seconds Sets the Mediatrix C7
Series in Partial
Reset Mode Sets some of the Mediatrix C7
Series configuration to pre-
determined values. All LEDs
• blinking, 1Hz,
50% duty
12 to 16 seconds Restarts the
Mediatrix C7 Series
in Factory Reset Deletes the persistent
configuration, creates a new
configuration file with the default
factory values, and then restarts
the unit. All LEDs
• steady ON
17 seconds and
more No action is taken The RESET/DEFAULT Button
Pressed event is ignored N/A