Media5 Mediatrix C710, Hardware Installation Manual

Page: 29 / 52

Indicators (LEDs) Hardware Installation Guide
Mediatrix C7 Series – Digital Gateway 17
LED Patterns – Default Behaviour
When no specific condition matches those described in Table 6 , the LEDs behave individually according to
the following rules:
UpdateInProgress A firmware pack is downloaded into the unit
and written to persistent storage. All LEDs:
• cycling from left to
right, individually
blinking 1Hz, 33%
duty
UpdateFailed Triggered after a failure of a firmware pack
download operation. After 4 seconds, the unit
restarts. All LEDs:
• blinking at 3Hz,
50% duty. One LED
out of two has a 180
degree phase. This
pattern lasts for 8
seconds.
Rescue Network
Enabled Triggered after the user has performed a partial
reset procedure. Power and Ready LEDs:
• blinking
(synchronized)
1Hz, 75% duty
BootOnRecoveryBank Triggered when the unit is booting on the
recovery bank and no update is pending. Power LED:
• blinking, 0.25Hz,
75% duty
Automatic network
configuration in
progress Waiting for DHCP (IPv4 or IPv6) answer or IPv6
router advertisement or PPPoE connection. All LEDs:
• Blinking green,
3Hz, 50% duty
No network address set Triggered when the unit cannot be contacted
because DHCP failed, PPP failed, and no static
interface is configured.
Power LED:
• blinking, 3 Hz, 50%
duty.
NetworkRescue The unit tries to download and install a firmware
given by the Network Rescue server. Ready LED:
• Off
All other LEDs:
• blinking to show a
LED displacing light
from left to right and
right to left.
Table 6: LED Patterns (Continued)
Condition Description LED Pattern
Table 7: Default LED Behaviour
LED Type Condition Behaviour
Power
RestartInProgress Blinking, 1 Hz, 50% duty
RestartCompleted Steady ON
ETH
Network traffic Blinking, variable rate
No network traffic Steady ON
ETH2
Network traffic Blinking, variable rate
No network traffic Steady ON