Media5 Mediatrix 4401, Hardware Installation Manual

Page: 26 / 54

Chapter 3 - Powering on the Mediatrix 4400 Indicators (LEDs)
16 Mediatrix 4400 – Digital Gateway
These procedures assume that you know the IP address of the Mediatrix 4400 you want to verify. If the
Mediatrix 4400 does not respond, do the following:

Verify that the WAN cable is securely connected to the Mediatrix 4400 and to the network
connector.

Be sure that you did not connect crossover network cables.

Verify the state of the IP network to ensure it is not down (the ETH1 or ETH2 LED should be
ON or blinking).
Indicators (LEDs)
The indicators (LEDs) of the Mediatrix 4400 are described in “Mediatrix 4400 Connectors and Indicators” on
page 2 .
LED Patterns – Specific Conditions
Table 7 describes the different states a Mediatrix unit can have and their associated LED patterns.
Table 7: LED Patterns
Condition Description LED Pattern
RestartPending Triggered when the RESET/DEFAULT button is
pressed in the ResetPending state. The unit
prepares for a physical shutdown and restart.
Power LED:
• blinking, 1Hz, 50%
duty
All other LEDs:
• OFF
RecoveryPending Triggered when the RESET/DEFAULT button is
pressed at start-time or for at least 7 seconds.
All LEDs:
• blinking, 1Hz, 50%
duty
DefaultSettingsPending Triggered when the RESET/DEFAULT button is
not released while in ResetPending state.
At run time, if the RESET/DEFAULT button is
released within 5 seconds, the unit applies
default settings, otherwise the action is
cancelled and the unit goes back to the
operation mode state or it resets.
At start time, the unit stays in this state until the
RESET/DEFAULT button is released. The unit
then applies the default settings and restarts.
All LEDs:
• steady ON
UpdateInProgress A firmware pack is downloaded into the unit
and written to persistent storage. All LEDs:
• cycling from left to
right, individually
blinking 1Hz, 33%
duty
UpdateFailed Triggered after a failure of a firmware pack
download operation. After 4 seconds, the unit
restarts. All LEDs:
• blinking at 3Hz,
50% duty. One LED
out of two has a 180
degree phase. This
pattern lasts for 8
seconds.