Media5 Mediatrix 4104, Reference Manual

Page: 55 / 466

Network Settings Reference Manual (SIP Version)
Mediatrix 4104 33
This command temporary locks/unlocks the selected line of the Mediatrix 4104. This state is kept
until the unit restarts. It offers the following settings:
2. Click Submit if you do not need to set other parameters.
Network Settings
The Network Settings sub-page of the Management page allows you to configure network-related parameters
of the Mediatrix 4104 grouped in three categories:

Ethernet

Network Settings

SNTP
Ethernet Connection Speed
You can set the speed of the Mediatrix 4104’s Ethernet connection.
You can also set this parameter via SNMP, as described in “Ethernet Connection Speed” on page 161 .

To set the Ethernet connection speed:
1. In the web interface, click the Management link, then the Network Settings sub-link.
Figure 15: Management – Network Settings Web Page
2. Set the Ethernet connection speed of the ETH1 connector in the Network Port Speed field.
The following values are available:
• Auto detect
• 10Mbs-HalfDuplex
Table 22: Temporary Lock Settings
Setting Description
noOp No action is taken.
unlock Registers the line to the SIP server.
lock Cancels the line registration to the SIP server. Active calls in progress
remain established until normal call termination. No new calls may be
initiated.
forcelock Cancels the line registration to the SIP server. All active calls in progress
are terminated immediately. No new calls may be initiated.
2