Media5 Mediatrix 4104, Reference Manual

Page: 30 / 466

Chapter 1 - Installation Choosing a Suitable Installation Site
8 Mediatrix 4104
Port Numbering Convention
The following describes the port numbering conventions of the FXS connectors available on the Mediatrix
4104.
Figure 3: FXS Connectors Port Numbering Convention
Choosing a Suitable Installation Site
The Mediatrix 4104 is suited for use in an office environment where it can be wall-mounted or free standing.
Location
Install the Mediatrix 4104 in a well-ventilated location where it will not be exposed to high temperature or
humidity. Do not install the Mediatrix 4104 in a location exposed to direct sunlight or near stoves or radiators.
Excessive heat could damage the internal components.
When deciding where to position the Mediatrix 4104, ensure that:

The Mediatrix 4104 is accessible and cables can be easily connected.

The cabling is away from the following:
• Sources of electrical noise such as radios, transmitters, and broadband amplifiers.
• Power lines and fluorescent lighting fixtures.
• Water or moisture that could enter the casing of the Mediatrix 4104.

The airflow is not restricted around the Mediatrix 4104 or through the vents in the side and back
of the unit. The unit requires a minimum of 25 mm (1 in.) clearance.

The operating temperature is between 0
o
C and 40
o
C.

The humidity is not over 85% and is non-condensing.
FXS
#4
FXS
#1
FXS
#3
FXS
#2
Warning:
The analog lines of the Mediatrix 4104 are not intended for connection to a telecommunication
network that uses outside cable.
Warning:
To prevent fire or shock hazard do not expose the unit to rain or moisture.