mectron MICROPIEZO, Use And Maintenance Manual

Page: 111 / 262

17
USE
Place the handpiece in the appropriate
housing available on the appliance.
8
5 USE
5.1 Power On/Off
To turn on the system, after completing the
procedure described in the Chapter 4.3 on
page 14 , it will be necessary to press and
hold the Power key for 2 seconds.
All the indicators on the keyboard will light up
and the system, once the start-up procedure is
complete, will emit an acoustic signal.
NOTE : During turning on, check that all
the indicators illuminate correctly and
that the system emits the acoustic signal.
If any indicator does not light up or the
system does not emit any sound, contact an
Authorised MECTRON Service Centre.
At the first ignition and after an unexpected
restart (for example, as a result of the
interruption not provided of the power
supply), the system will be configured with the
following settings:
• power 0
• water 0
•
SOFT MODE
non active
•
LIGHT
active
• Wi-Fi active
•
FLUSH non active
NOTE : For the description of the above
settings refer to Chapter 5.2 on page 18 .
In all the other conditions, the system will be
configured with the last settings used before
proper shut-down.
CAUTION: With the pedal pressed down,
the system will still boot, as provided in
conditions of normal use, but will inhibit all
the commands and configuration changes.
This condition will be signalled by the
flashing symbol and 0 value on the
irrigation scale. For information, refer to
Chapter 12.1 on page 70 .
To turn the system off, press and hold again
the Power key for 2 seconds.
Similarly to what occurs during start-up, the
system will disable all the indicators and will
emit an acoustic signal.
CAUTION: Place the appliance in such
a way as to always have the power plug
easily accessible as it is considered to be a
disconnection device.