RTU Modbus interface : MPNC006 Mect srl
7
ME7084_05 07/21
2.3
Installation
2.3.1
Distances
The system must be installed in a way that there is enough space for heat dissipation
and cabling. Avoid cables superimposition to prevent EMC problems.
Figure 2
2.3.2
Insertion and removal of components
Attention
Before performing these operations make sure that devices are
not supplied.
2.3.3
Assembly sequence
The insertion or removal of a single terminal is carried out by acting on the
fastening hook to the DIN rail
located at the base of the terminal itself as shown in
the figure
. The sequence starts with the insertion of the MPNC006, then the
necessary terminals are inserted in sequence. The fixing to the DIN rail is
guaranteed by the hooking spring of each terminal.
Adding terminals Removing terminals
Figure 3: Insertion or removal of a terminal