Page 37
Mcro 26 - Operator’s Manual
March 2019
Secton 11 - Transportng and Lftng Instructon
Driving or Winching onto or off of a Transport Vehicle
Always attach the machine to a winch when loading or unloading from a
truck or trailer by driving�����
Read and understand all safety, control, and operating information found
on the machine and in this manual before operating the machine�����
FORK LIFT
POCKETS
ART_5030
Before loading or unloading the machine, check that:
The deck extension, controls and component trays are
secure.
The platform is fully lowered.
All loose items have been removed.
Before driving or winching the machine:
Attach the machine to a winch.
Remove all machine tie downs. Remove wheel chocks.
Driving
Turn the Base Key Switch to PLATFORM. Check that the
Emergency Stop Switch is reset by turning it clockwise.
Enter the platform and reset the Platform Emergency Stop
Switch.
Test platform control functions.
Select slow drive speed mode. Carefully drive the machine
off the transport vehicle with the winch attached.
Note:
The brakes are automatically released for driving and will
automatically apply when the machine stops.
Winching
Disengage brakes (see Free-wheel configuration for
Winching or Towing on page 36).
Carefully operate the winch to lower the machine down the
ramp.
Chock the wheels and engage the brakes.
Lifting The Machine With A Forklift
Position the forklift forks in line with the forklift pockets.
Drive forward to the full extent of the forks.
Raise the machine 6 in / 15 cm and then tilt the forks back
slightly to keep the machine secure.
Be sure the machine is level when lowering the forks.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Lifting the machine from the side may result in component damage�����
