Chapter 6
Specifications
Typical for 25 °C unless otherwise specified.
Specifications in
italic text
are guaranteed by design.
Analog input
Table 1. Analog input specifications
A/D converter type
Sub-ranging sampling ADC
Resolution 16
bits
Number of channels
32 differential or 64 single-ended, software selectable
Input ranges
(software programmable)
±5 V, ±2.5 V, ±1.25 V, ±0.625 V, 0 to 5 V, 0 to 2.5 V, 0 to 1.25 V
Polarity
Unipolar/bipolar, software selectable
A/D pacing
(software programmable)
!
Internal counter – ASIC
!
External source (A/D external pacer). The total number of sample clocks must be at least
5 greater than the total number of samples desired. This is required to accommodate the
pipelined architecture of the ADC.
!
Software polled
Burst mode
Software selectable option. Valid for a fixed input range only.
Burst rate = 1 µS.
A/D gate sources
!
External digital (A/D pacer gate)
!
External analog (analog trigger in)
External digital: Programmable, active high or active low, level or edge
A/D gating modes
External analog: Software-configurable for:
!
Above or below reference
!
Positive or negative hysteresis
!
In or out of window.
Trigger levels set by DAC0 and/or DAC1.
A/D trigger sources
!
External digital (A/D start trigger in and A/D stop trigger in)
!
External analog (Analog Trigger In)
A/D triggering modes
!
External digital: Software-configurable for rising or falling edge.
!
External analog: Software-configurable for positive or negative slope. Trigger levels set
by DAC0 and/or DAC1.
!
Pre-/post-trigger: Unlimited number of pre-trigger samples, 16 Meg post-trigger
samples. Compatible with both digital and analog trigger options.
Data transfer
!
From 8 k RAM buffer via DMA (demand or non-demand mode) using scatter gather.
!
Programmed I/O
Configuration memory
8 K words
Channel/gain queue
Up to 8 K elements. Programmable channel, gain, and offset.
A/D conversion time
1 µS
Calibration
Auto-calibration, calibration factors for each range stored on board in non-volatile RAM.
6-4
Summary of Contents for PCI-DAS64/M1/16
Page 1: ......