8
Tractor-ECU application
Configuring the parameters for a vehicle profile
60
V7.20160121
30302710-02-EN
6. Select whether you want to invert the signal. Inversion only makes sense when you have
selected "digital" or "ME-sensor Y".
7. If you have selected "digital" or "ME-sensor Y":
- Return to the vehicle profile.
OR
If you have selected ”analog“: Move the hitch to the height at which the working position starts.
8.
Press to confirm.
9.
- Return to the vehicle profile.
⇨
You have configured the working position sensor.
Entering the position of the GPS Receiver
When you have mounted and connected the GPS receiver, you must enter its exact position.
For the parallel guide with TRACK-Guide II you can skip this section. You must enter the position of
the GPS receiver in the "Machine profile" screen of the TRACK-Leader application.
If you use TRACK-Guide II with a SECTION-Control box, you must enter the position of the GPS
receiver here.
In order to enter an accurate position for the GPS receiver, you must measure the distances of the
GPS receiver from the longitudinal axis and from the so-called attachment point [
When entering distances, please note that it is essential to specify whether the GPS receiver is to the
left or right of the tractor's longitudinal axis and whether it is positioned before or after the attachment
point.
What is the position of the GPS receiver?
The distance should be entered as follows
to the right of the longitudinal axis
y
to the left of the longitudinal axis
- y
before the attachment point
x
after the attachment point
- x
1. Call up the Tractor-ECU application:
| Tractor-ECU
2.
- Call up the list of vehicles.
3. Select the vehicle profile.
4.
- Press.
8.2.3
Procedure
