![Me TRACK-Guide II Installation And Operating Instructions Manual Download Page 47](http://html1.mh-extra.com/html/me/track-guide-ii/track-guide-ii_installation-and-operating-instructions-manual_1757540047.webp)
Configuring the terminal in the Service application
Setting the purpose of the terminal
7
30302710-02-EN
V7.20160121
47
▪ Item number of the terminal – Found on the nameplate on the reverse of the terminal.
The activation number is entered as follows:
1. Switch to the "Licenses" screen:
| Service | Licenses
⇨
The following screen will appear:
2. Click on the desired application.
⇨
The following screen will appear:
3. Enter the activation number in the "Key" field. You will receive the activation number on
purchasing a software license.
4. Confirm
⇨
The following icon will appear next to the application on the "Licenses" screen:
⇨
The application is activated. You can use the application without any restrictions.
Setting the purpose of the terminal
If you use more than one terminal, you can decide how you want to use this terminal.
The following options are available to you:
▪ "Login as ISOBUS-UT"
Activate this parameter if you want the ISOBUS job computer to be displayed on the terminal.
This parameter must be activated in most instances. On very few self-propelled agricultural
machines, the parameter must be deactivated.
▪ "Run as auxiliary terminal"
The ISOBUS job computer does not log into terminals which log in as "auxiliary terminal".
1. Switch to the "Display configuration" screen:
| Service | Display configuration
Procedure
7.13
Procedure