Technical Manual
Motion Detector/Automatic Switch 55/63
Series .02
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1
Tel.: +49-2263-
880 • Fax: +49-2263-4588 • [email protected] • www.mdt.de
25
25
4.3.4.3 Output object: Scene
The following settings are available:
Figure 12: Settings
–
Output object: Scene
With
“S
cene number for Day/Night when ON/OFF
”
, the corresponding scenes are defined, which the
channel sends after detection has taken place or after the follow-up time has elapsed.
The following table shows the available communication objects:
Number
Name/Object Function
Length
Usage
0
Light channel 1 - Output 1
–
Scene
1 Byte
Scene function of the light channel
2
Light channel 1 - Output 2
(Additional)
–
Switch
1 Bit
Second switching function of the light
channel
60
HVAC - Output 1
–
Scene
1 Byte
Scene function of the HVAC channel
Table 13: Communication objects
–
Output object: Scene
4.3.4.4 Sending conditions for output objects
The sending conditions can be set for all three object types (here: switch):
Figure 13: Settings
–
Sending conditions for output objects
When selecting "
Output object 1 sends
", it is possible to define what is to be sent at the output. The
selection, according to the selected type, is as follows:
Switch:
only ON / only OFF / ON and OFF
Dimming absolute:
only dimming value for ON / only dimming value for OFF /
dimming value for ON and OFF
Scene:
only scene number for ON / only scene number for OFF / ON and OFF
Send "ON" cyclically
The output object 1 (depending on the configuration switch, dimming absolute or scene) can send
the configured value for "ON" cyclically. The time interval can be set between 10 s and 60 min.
In addition, the second switching object (only light channel) can send its value cyclically.
