Technical Manual
Motion Detector/Automatic Switch 55/63
Series .02
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1
Tel.: +49-2263-
880 • Fax: +49-2263-4588 • [email protected] • www.mdt.de
18
18
4.3.2 Basic settings
–
HVAC channel
HVAC channel
The following picture shows the basic settings for the HVAC channel:
Figure 6: Basic settings
–
HVAC channel
The following table shows the possible settings for these parameters:
ETS-Text
Dynamic range
[Default value]
Comment
Active sensors
•
--
•
1-
•
-2
•
12
Setting which sensors are active for this
channel.
Information about
sensor assignment
Position of sensors
If the mark is set by clicking on the
checkbox, a sketch appears with
information about the positions of the
sensors S1 and S2.
Channel mode
•
fully automatic
•
half automatic (manual
switching)
Setting whether the device operates as a
fully automatic or semi-automatic device.
Number of monitoring
time slots
1
–
30
[3]
Setting the number of observation time
windows.
Length of monitoring
time slot
0 … 30000
[30]
Setting the length for each of the
observation time windows.
Follow-
up time “Day”
1 s
–
4 h
[3 min]
Setting the follow-up time for Day mode.
Follow-
up time “Night”
1 s
–
4 h
[30 s]
Setting the follow-up time for Night
mode.
Table 7: Basic settings
–
HVAC channel
