Technical Manual
Glass Push-button II Smart & Push-button Smart 86 [Series .02]
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1 • Germany
Phone: +49-2263-
880 • [email protected] • www.mdt.de
87
87
LED display behaviour
for „Day“ (value ON)
any colour
Colour for the object value ON when the
button is pressed in Day mode.
for „Day“ (value OFF)
any colour
Colour for the object value OFF if no
button is pressed in Day mode.
Behaviour for „Day“
(value ON)
▪
permanent
▪
flashing
Setting the lighting behaviour when LED
has the object value ON, or the button is
pressed.
for „Night“ (value ON)
any colour
Colour for the object value ON when the
button is pressed in Night mode.
for „Night“ (value OFF)
any colour
Colour for the object value OFF if no
button is pressed in Night mode.
Behaviour for
„Night“
(value ON)
▪
permanent
▪
flashing
Setting the lighting behaviour when LED
has the object value ON, or the button is
pressed.
Table 70: Settings
–
LED 1-12/A/B
Each LED can react either to any external object
or
internal object
or
to button activation.
In addition, a LED can also react to an “external/internal object
and
the button activation”. With this
setting, the adjustments in the menu LED 1-12/A/B refer to the control of the LEDs via the object. In
this case, the behaviour of the button operation is set globally for all LEDs and is described in chapter
The behaviour for the button activation has priority here.
If the setting LED reacts to "
internal object
" is selected, the object number to which the LED is to be
linked is selected. For example, if the LED is to switch when (with the setting "Button 1" to "toggle")
the "Object 1 - Status for toggle" has the value "1", the object number "1" must be entered. In this
case, the status LED would be switched on if the object has the value "1" and switched off if the
object has the value "0".
If the LED is linked to an object that does not have the size 1 bit, the LED is switched off if the object
has the value "0" and switched on if the value of the object is not equal to "0". For an object of the
"DPT 5.001 - Percent", this means that the LED is switched off at 0% and switched on at all other
values.
With the setting "
LED reacts to: external object
", the corresponding LED can be controlled either via
a 1-bit object or 1-byte objects as a percentage value or decimal value.
With
DPT "Switch"
the LED is switched on with a "1" and with a "0" the LED is switched off.
With
DPT "Percent value"
, the LED switches on with the set value and switches off again when the
value falls below this value.
With
DPT "Decimal value"
, sending the following object values causes the corresponding colour.
The following note appears in ETS:
The colours listed are the most used standard colours. However, other colours are also possible.
