Technical Manual Switch Actuator 3-fold, FanCoil
MDT technologies GmbH
•
51766 Engelskirchen
•
Papiermühle 1
Tel.: +49-2263-
880 • Fax: +49
-2263-4588
• [email protected] • www.m
dt.de
53
Minimum holding time of each step:
The minimum holding time of each step can be used for avoiding too many changeovers between the
steps. Only after the minimum holding time is elapsed, the FanCoil actuator switches into the next
level. In this example, step 3 is switched on and step 0 is active. The steps are driven in succession:
Figure 40: Minimum holding time of each step
Switch-On behavior:
If the FanCoil must be switched on with a defined level, this can be adjusted by the parameter
“ it h
-
O Beha ior a d Mi i u holdi g ti e of startup le el . I the follo i g
example, the
FanCoil, is switched on with level 3 and the levels are controlled in succession:
Figure 41: Switch-On Behavior
If the para eter “ it h
-
O eha ior is set to dire t start , the Fa Coil ould e start dire tl ith
level1.
Summary of Contents for AKK-03UP.02
Page 6: ......
