Technical Manual Switch Actuator 3-fold, FanCoil
MDT technologies GmbH
•
51766 Engelskirchen
•
Papiermühle 1
Tel.: +49-2263-
880 • Fax: +49
-2263-4588
• [email protected] • www.m
dt.de
25
The following table shows the available settings for the behavior at bus power down/up:
ETS-text
Dynamic range
[default value]
comment
Behavior at bus power up
Off
On
no change
Behavior at bus power failures
Behavior at bus power down
Off
On
no change
Behavior when bus power
returns
Table 12: Behavior at bus power down/up
5.2.5 On/Off delay
The following illustration shows the setting options at the ETS-Software:
Figure 10: On/Off delay
The on-delay causes a delayed switch of the channel. At sending an on-signal to the channel, first the
adjusted on delay time expires and afterwards the channel will be switched on.
The off delay works on the same principle. At sending an off-signal, first the adjusted off delay time
expires and afterwards the channel will be switched off.
Both fu tio s ork as ell alo e as o
i ed. B adjusti g se o ds for a dela the fu tio is
switched off.
The following diagram describes the combination of on and off delay:
Summary of Contents for AKK-03UP.02
Page 6: ......
