ANI Monitor V2 - Continuous analgesia monitoring system
MD/PRD/IN16.ANIV2 v.07 - 12 MAR 2020
P a g e
12 | 45
3
Installating the ANI Monitor V2
3.1
Perfusion stand
Position the ANI Monitor V2 so that the main power supply can be easily plugged in. The
monitor can be installed on a perfusion stand by using a specific "pole clamp", which fit pole
diameters ranging from 19 to 38 mm.
The user is responsible for ensuring that a suitable stand is used.
3.2
Table
A system available for ANI Monitor V2 allows it to be placed on a flat surface.
3.3
ANI Sensor V1 / ANI Sensor V2 / ANI Sensor V1 PLUS
The electrodes are composed of a two-part device: a dual sensor and a single sensor
connected together by an electrical thread.
The sensor itself is divided into two areas. One part is an adhesive area and the other, the
active area, is covered with conductive gel
The principle of this two-part device is to place it on each side of the heart (thus on each side
of the chest) to get a cardiac vector (the axis of the average cardiac vector according to the
reference anatomical position is: forward, down and left). In this case the dual sensor is
applied on the patient's chest, the big patch on the upper chest and the small patch on the
left side of the chest
.
WARNINGS:
Reusing a sensor already used on another patient could lead to a risk of cross-contamination.
Adhesive side
conductor
