McNeilus HD Rear Loader, Operator'S Manual, Page: 51 / 132

© 2008 McNeilus Truck and Manufacturing, Inc.
Rear Loader
37
General Information
1.3.2 Type T Container More Than 3 yd
3
and Less
Than 10 yd
3
Capacity
Only lift containers that are compatible with ANSI Z245.60-
2008 type T containers greater than 3 yd
3
and less than
or equal to 10 yd
3
capacity. Before lifting, ensure that the
container meets the dimensional requirements as described in
the following table and detailed in Figure 4.
No. Description Specification
1
Total length of the trunnion bar including
washers if provided. If washers are
provided, their diameter should be 2-1/4 in.
Min: 77-1/2 in.
Max: 78 in.
2
Width of container and all the supporting
gussets attached to the trunnion bar.
Max: 72 in.
3
Width of the container body including
structural supporting side members (“side
rails”). This dimension excludes handles
and gusset supports.
Max: 66 in.
4
Diameter of trunnion bar at latch-up points. Min: 1-1/4 in.
Max: 1-3/4 in.
5
The maximum diameter (thickness) of an
attachment through which a cable may be
hooked to the container.
Max: 1-1/4 in.
6
The inside width of an attachment through
which a cable may be hooked to the
container.
Min: 2 in.
Max: 3 in.
No. Description Specification
7
The distance from the center line of the
trunnion bar to the ground. The top of the
trunnion bar should coincide with the top
of the container on the side where the
trunnion bar is located.
Min: 45 in.
Max: 49 in.
2
1
3
6
5
7
4
Figure 4