McDonald's C602, Manual

Page: 3 / 114

1
INTRODUCTION
The Model C602 is a combination shake and soft serve
freezer. The soft serve side uses a 3.4 qt. (3.2 L) freezing
cylinder with a single-spout door.
The shake side has a 7 qt. (6.6 L) freezing cylinder with a
four-flavor dispensing door. The touch panel has four
flavor symbols for selecting and drawing the desired
shake flavor. When dispensing a shake, the cup is placed
on the shake cup holder below the door spout. A shake
flavor symbol is selected to automatically raise the
draw valve, allowing frozen mix and syrup to enter the
door where they are blended and dispensed as a finished
shake.
A portion control device will sense the filling of the shake
cup and automatically close the draw valve upon filling
the shake cup to the correct level. The operator also has
the ability to override the portion control and stop
dispensing the shake by pressing any of the four shake
flavor symbols. The shake draw valve can also be raised
and lowered in the Wash and Off modes by selecting any
of the four flavor symbols to enable cleaning, sanitizing,
and priming.
Shake syrup is stored in the lower front compartment.
Each syrup flavor is delivered to the dispensing door by a
peristaltic pump. Syrup can be pumped directly from
disposable plastic jugs or stainless steel tanks, or
adapted to syrup-in-bag dispensing. The proper syrup
delivery rate is achieved by calibrating each syrup flavor.
The mix is located in the mix hopper and is pumped to
the freezing cylinder by an air/mix pump.
When your machine is delivered, or if it has been in the
OFF position for more than 24 hours, disassemble the
freezer following the Manual Brush-Cleaning procedures
on page 48. Follow the Equipment Setup procedures on
page 59 to reassemble your machine.
The machine must be disassembled, cleaned, sanitized,
and lubricated at least once every 2 weeks. Syrup lines
must be cleaned and sanitized weekly.
It is recommended that these operating procedures be
followed closely to ensure correct assembly and
disassembly of the freezer.
The C602 is designed for indoor use only.
Note: Only instructions originating from the factory or its
authorized translation representative(s) are considered to
be the original set of instructions
.
SAFETY
Always follow these safety precautions when operating
the freezer:
NOTICE! DO NOT operate this machine
without reading this manual. Failure to follow these
instructions may result in machine damage, poor
dispenser performance, health hazards, or personal
injury.
IMPORTANT! This machine is to be used only
by trained personnel. It is not intended for use, cleaning,
or maintenance by children or people with reduced
physical, sensory, or mental capabilities, or lack of
experience and knowledge, unless given supervision or
instruction concerning the use of the
machine by a
person responsible for their safety. Children should be
supervised to ensure that they do not play with the
machine.
WARNING! Avoid injury.
• DO NOT operate the machine unless it is
properly grounded.
• DO NOT operate the machine with fuses larger
than specified on the machine's data label.
• All repairs should be performed by a Taylor
service technician.
• The main power supplies to the machine must
be disconnected prior to performing installation,
repairs, or maintenance.
• For Cord-Connected Machines: Only Taylor
service technicians or licensed electricians may
install a plug or replacement cord on the
machine.
• Machines that are permanently connected to
fixed wiring and for which leakage currents may
exceed 10 mA, particularly when disconnected
or not used for long periods, or during initial
installation, shall have protective devices to
protect against the leakage of current, such as a
GFI, installed by the authorized personnel to the
local codes.
• Stationary machines which are not equipped