McAfee AVDCDE-AA-AA - Active Virus Defense Suite, User Manual, Page: 54 / 344

Installing VirusScan Software
54 McAfee VirusScan Anti-Virus Software
If VirusScan software does not detect any viruses during its scan
operation, Setup will immediately copy BOOTSCAN.EXE and its
support files to the floppy disk you created. If VirusScan software
does
detect a virus, quit Setup immediately. See “If you suspect you have a
virus...” on page 59 to learn what to do next.
4. When the wizard finishes copying the Emergency Disk files, it displays
the final wizard panel ( Figure 2-19 ).
Figure 2-19. Final Emergency Disk panel
5. Click
Finish
to quit the wizard. Next, remove the new Emergency Disk
from your floppy drive, label it, write-protect it, and store it in a safe
place.
Š
NOTE:
A locked or write-protected floppy disk shows two holes
near the edge of the disk opposite the metal shutter. If you don’t see
two holes, look for a plastic sliding tab at one of the disk corners,
then slide the tab until it locks in an open position.
Determining when you must restart your computer
In many circumstances, you can install and use this VirusScan release
immediately, without needing to restart your computer. In some cases,
however, the Microsoft Installer (MSI) will need to replace or initialize certain
files, or previous McAfee product installations might require you to remove
files in order for VirusScan software to run correctly. These requirements can
also vary for each supported Windows platform.
In these cases, you will need to restart your system during the
installation—usually to install MSI files—or after the installation itself.