MBW MK8-75, Operator'S Safety And Service Manual

Page: 40 / 68

40 of 68
Before carrying the maintenance of the
machine ensure you understand the contents
of
this manual. Please contact the
manufacturer for further explanations and
information.
Maintenance workers must
possess the skills required by this manual, as
well as the mental and physical requirements
necessary and sufficient in order to operate
the machine. To ensure the functionality and
durability
of the machine periodic
maintenance must be performed, carrying out
operations in compliance with the safety
requirements.
Only the reseller (authorized dealer) can
make adjustments and operations that are
not assigned to the operator. It is
forbidden to make adjustments and
interventions during machine operation.
Before
performing any maintenance
operation disconnect the machine from
the power sources and wait for the
cooling of the hot parts (engine, spark-
plug area, air filter area).
!
CAUTION
Some operations of
maintenance/replacement of worn
components may only be carried out
by the authorized dealer or the
manufacturer's technician. They are
reported later in this publication.
Please note that failure to comply
with
the requirements of
maintenance represents a possible
MISUSE or PROHIBITED USE and
relieves the manufacturer from any
liability for damage to persons and
property.
1. To stop the machine, bring the
accelerator at idle speed, by
activating the accelerator lever.
2. Release both control bars.
3. Close the petrol tap.
4. Stop the engine (position the switch to
the OFF/0).
5. Remove the ignition key from the
control panel.
6. Carry out maintenance operations
with the machine stopped.
Before performing maintenance:
1.
Thoroughly clean the trowel machine
because due to wear the blades can become
sharper. During maintenance check carefully
the blade position and be equipped with anti-
cutting gloves.
If in doubt about how to perform
occasional repairs contact our Technical
Support or authorized dealer.
2. Upon finishing the job perform a
thorough cleaning from processing residues.
3.
After the cleaning process, replace
the feather edge disk under the blades to
protect them from any damage caused by
movement of the machine
.
6.1 SCHEDULED MAINTENANCE
Good maintenance requires constant and
methodical control of all parts of the machine
and adaptation of tests to its actual usage.
Periodic inspections are crucial to keep the
machine efficient and reduce repairs and any
resulting dangers.
We recommend that you have your
reseller (AUTHORIZED DEALER) perform
a general annual check.
Note: frequency is taken over considering
a working day of 8 hours.
!
CAUTION
During the execution of maintenance tasks you must wear the
following P.P.E.: CUT RESISTANT GLOVES AND SAFETY SHOES.
For certain types of activities (lubricant filling-up) make use of airway protection
equipment as indicated in the residual risks.