Alterations reserved
Operating Manual
SAP 46 L ENG
Stand 01/2004
Page 18
5.3
Batch counter
5.3.1
Batch counter
Enter the desired quantity of sheets
per batch into the batch counter 1
through the pre-selector 2.
The progress of the batch and the
number of the remaining sheets
are can be checked at the electronic
display 3. This display can be deleted
at the reset button 4 after completion
of the job.
5.3.2
Marking device
Affix the kicker 1 so that the photocell 2
will detect the oncoming sheet.
Functioning check: the red diode at
the amplifier 3 must be lit.
The kicker slide 4 must displace the
sheet for approximately 10-15 cm to the
left side.Therefore, you should position
the counter-stop 5 accordingly.
If unstable sheets start to crease at
the kicker
slide you should affix a U-profile 6.
