Alterations reserved
Operating Manual
SAP 46 L ENG
Stand 01/2004
Page 12
3.3
Erection
Transport the SAP 46 L to the individual
exit of the folding machine.
Loosen the T-screws 1 and set the
infeed height by manually turning
the handwheel 2.
The infeed tapes 3 should be slightly
deeper than the sheets that are
running out from the folding machine.
Secure the position of the delivery
through the locking devices 4 at
the transportation rollers 5.
Make sure that the centre of the sheet
corresponds with the centre of the
delivery.
3.4
Electrical connections
Connect the SAP 46 L to the folding
machine with the power supply plug 1
and the control plug 2.
Due to its self-drive it may also be
connected to foreign machines.
For this purpose, connect the power
supply plug 1 with the mains system
and insert the control plug into the
socket „Self-drive“ 4 at the control
cabinet. Make sure that both units
may be turned ON and OFF separately.
>DANGER< Please be advised that
there is no joint current interruption if
connected to foreign machines.
The manufacturer and the supplier will
not assume liability caused by lack of
safety disconnection.
