37
3-22 Replacing the Clincher Motor
1. Following the steps in
3-1 Replacing the Outer Covers
, remove the front cover, the rear cover,
and the side cover R.
2. Disconnect connector J3 from the circuit board.
3. Cut the cable tie that binds cable J3 from the motor to the circuit board.
4. Unfasten the set screw to remove the gear. Then unfasten four screws to remove the motor.
(Pay attention to attachment of grease.)
5. After the replacement, take the reverse steps to reassemble the product.
List of Components
No.
Name
Qty.
283
Gear
1
112
Clincher Motor
1
507
Lithium Grease
-
NC3x6
Washer-Equipped Screw (small)
4
SS4x4
Set Screw
1
Connector J3
Cable Tie
283 [Gear]
SS4x4
112
[Clincher Motor]
4-NC3X6
Greasing Positions
Apply 507 [Lithium Grease]
onto the whole surface.
Use grease at NLGI No.2.
(AZ’s DS768 is recommended.)
