MBM 6020001, Operator'S Safety And Service Manual, Page: 7 / 31

- 2 -
OPERATION
Introduction
MBW equipment is intended for use in very severe
applications. They are available in different sizes and a
selection of engines and motors.
This parts manual contains only standard parts. Variations
of these parts as well as other special parts are not included.
Contact your local MBW distributor for assistance in
identifying parts not included in this manual.
Before Starting & Operating
• REMEMBER! It is the owner’s responsibility to
communicate information on the safe use and proper
operation of this unit to the operators.
• Review ALL of the Safety Precautions listed on page 1 of
this manual.
• Familiarize yourself with the operation of the machine
and confirm that all controls function properly.
• Know how to STOP the machine in case of an
emergency.
• Make sure hands, feet, and clothing are at a safe
distance from any moving parts.
Attaching Blade
Refer to Figure 1.
1. Loosen the bolts that secure the clamps to the exciter
assembly.
2. Lay the float blade on the floor with the decals facing
upward.
3. Center the exciter between the “Exciter Location”
decals on the float blade.
4. Tilt the exciter forward and hook the small leg of the
clamping plates under the front lip of the float blade.
5. Set the exciter onto the blade so the rear part of the
exciter casting lines up with the rear cavity of the float
blade.
6. Tighten the clamping plate bolts.
Starting Screed
1. Insert battery and latch cover. Throttle must be fully
closed when battery is in inserted.
For Best performance use only Milwaukee Tool’s M18
TM
REDLITHIUM
TM
HIGH OUTPUT
TM
batteries.
2. Turn throttle.
Stopping Screed
1. Move throttle to idle position.
WARNING
Always stop the motor before:
Replacing battery.
Before making any repairs or adjustments to the
machine.
Float Blade
Exciter
Clamping
Plate
Bolt
Figure 1.