MB Connect Line mbNET.rokey RKH 210, Manual

Page: 319 / 324

33 Programming the mbCONNECT24 portal configuration via the USB interface
If you created the mbNET device configuration in the mbCONNECT24 service portal, you can scan this portal
configuration directly via the USB interface into the mbNET. The device automatically detects the portal con-
figuration stored on a connected USB Stick ("mbconnect24.mbn/-.mbnx”).
Pressing the Dial Out button starts the scan.
Requirement:
You have configured the mbNET in the mbCONNECT24 portal and saved the configuration file via transfer
type "Download to PC configuration" on a USB stick.
N O T I C E
The configuration file "mbconnect24.mbn/-.mbnx" must not be renamed and must be stored in the top-level
directory (root) of the USB stick!
The USB stick must have the FAT/FAT32 file format!
You can find information about mbCONNECT24 on
•
our website at www.mbconnectline.com
•
or in the mbCONNECT24online help
Execution:
When the mbNET is ready for operation (LED Pwr + Rdy light up), connect the USB stick to one of the USB
ports of the device.
1. As soon as the firmware file has been detected by the mb-
NET,LED Fc1 + Fc2 start flashing.
2. Now press the Dial Out button and keep it pressed until LED
Fc3 flashes.
3. Release the Dial Out button.
Now, the settings from mbCONNECT24 are applied in the
mbNET, and the device restarts.
4. If the mbNET can connect to the Internet (for example, network
cable, SIM card, antennas installed) it logs on to
your mbCONNECT24-account. This is indicated by the flashing
Con LED
N O T I C E
If both the firmware as well as a mbCONNECT24 portal configuration are on the USB stick, the firmware
will always be detected by the mbNET (Fc1 + Fc3 flash). If you do not press the Dial Out button within 10
seconds, the mbNET switches to Portal Configuration (Fc1 + Fc2 flash). If you do not respond within 10
seconds, the device will return to normal mode.
Programming the mbCONNECT24 portal configuration via the USB interface | Page 319 of 324