Page 12 on 20
DATE 13/04/2022
A0 version
6.2
Choice of treatment
Refer to the Biostim user manual.
6.3
Setting the parameters
Turn on the device and click on the Bluetooth logo (under the house). When the accessory is
connected, the Bluetooth logo turns green, and the logo of the connected accessory appears
on the right with a bar graph indicating the available battery level
The accessory is then used like the other probes, by choosing the channel to be used that
corresponds to the probe in the BFB menu.
If the Biostim is not connected to the PC, the duration of the programs is limited to 1 minute.
When accessing the treatment, and before launching it, it is necessary to set up the tray:
Clicking on the tray logo to the right of the Bluetooth symbol opens the configuration page.
This page allows you to configure the tray
type:
2 axis tray (ball type)
Or 1 axis (support on a bar)
Then, the calibration is done by putting the
device in the right stop, then before, and by
clicking on the adjustment logo for each
step.
Note: During adjustment, the movement of the dot on the target may be reversed. After
adjustment, the movement of the stage should cause the dot on the target to move in a
consistent manner.
