Do not step on the charge cable or
drag it on the ground.
When inserting/pulling out the
charge connector and the charge
plug, do not twist them excessively.
Do not apply excessive force to the
connected charge connector such as
by applying your weight.
Keep objects which generate intense
heat (such as a heater or cigarette)
away from the charge cable.
Do not apply organic solvents, acid
or alkaline agents to the charge
cable.
CAUTION
Do not connect the booster cable to
the lead-acid battery or remove the
lead-acid battery while charging the
high voltage battery. Otherwise, the
vehicle or charging device could be
damaged.
If the charge connector is removed
after the charging is finished, close
the charge port cap immediately. If
the charging lid is closed with the
charge port cap open, water or
foreign matter may enter the charge
port causing a malfunction.
Always make sure that the charge
cable is not connected to the vehicle
before driving. Because the vehicle
can be driven even while the charge
connector is not connected
completely, it could result in an
accident.
If the charge port is frozen shut,
defrost the inlet using a hair dryer. If
the charge cable is inserted/pulled
out with the charge port frozen, it
could cause damage.
NOTE
Normal charging and quick charging
cannot be performed at the same
time.
The navigation system and the
climate control system can be used
even while charging. However, the
charging time increases because
electrical power is consumed. In
some cases, power consumption
may exceed the charged amount and
charging may not finish.
If a power outage occurs while
charging, remove the plug and the
charge connector and start charging
from the beginning again.
Make sure that no water has
accumulated in the charge connector
and the charge port before charging.
If any foreign matter enters the
charge connector or the charge port,
do not start charging and consult an
Authorized Mazda Dealer.
▼
Preparation Before Charging
This vehicle is driven by consuming the
electrical power stored in the high
voltage battery. Therefore, it is
necessary to charge the high voltage
battery.
The parts related to charging are
located in the following positions.
Before Driving
Electric Vehicles
3-11
MX-30_8JD4-EA-21G_Edition4_new
2021-8-5 15:25:29
Summary of Contents for MX-30 2022
