Mazda MX-30 2022, Owner'S Manual Leaflet

Page: 451 / 546

Refer to Accessory Sockets on page
5-39.
1. Compressor plug
2. Compressor
CAUTION
When inserting the air compressor
plug into or removing it from the
accessory socket, make sure that
the air compressor switch is off.
When turning the air compressor
on/off, use the air compressor
switch.
11.The sealant is injected into the tire
when the air compressor is
switched on. After the sealant is
injected completely, wait until the
tire inflation pressure increases to
the specified tire inflation pressure.
NOTE
The inflation pressure may increase
to about 300 kPa (3.1 kgf/cm
2
, 3
bar, 43.5 psi) temporarily to inject
the sealant through the valve.
Normally, the inflation pressure
decreases gradually and it reaches
the actual inflation pressure after
about 30 seconds.
WARNING
Never use the air compressor
above 300 kPa (3.1 kgf/cm
2
, 3
bar, 43.5 psi):
Using the air compressor at an
inflation pressure above 300 kPa
(3.1 kgf/cm
2
, 3 bar, 43.5 psi)
continuously is dangerous. If the air
compressor overheats, hot air will
be exhausted and you could get
burned.
NOTE

Check the tire inflation pressure
label rear door on the driver's
side for the correct tire inflation
pressure.

Do not operate the air
compressor for a continuous 10
minutes or longer because using
it for long periods could cause a
malfunction.

If the tire inflation pressure does
not increase, repair of the tire is
not possible. If the tire does not
reach the specified tire inflation
pressure within 10 minutes, it
may have received extensive
damage. In this case, the repair
using the emergency flat tire
repair kit was not successful.
Contact an Authorized Mazda
Dealer.
If Trouble Arises
Flat Tire
7-7
MX-30_8JD4-EA-21G_Edition4_new 2021-8-5 15:25:29