Black plate (105,1)
NOTE
Before washing your Mazda, make sure
the sunroof is completely closed so that
water does not get inside the cabin area.
After washing your Mazda or after it
rains, wipe the water off the sunroof
before operating it to avoid water
penetration which could cause rust and
water damage to your headliner.
q
Tilt Operation
The rear of the sunroof can be tilted open
to provide more ventilation.
To fully tilt automatically, momentarily
press the rear of the tilt switch.
To stop tilting partway, press any part of
the tilt or slide switch.
To close to the desired position, press the
front of the tilt or slide switch.
Close
Close
Tilt up
q
Slide Operation
To fully open automatically, momentarily
press the rear of the slide switch.
To stop sliding partway, press any part of
the tilt or slide switch.
To close to the desired position, press the
front of the tilt or slide switch.
Close
Open
Close
q
Power Sunroof Re-set Procedure
If the battery is disconnected, the sunroof
will not operate. The sunroof will not
operate correctly until it is re-set. Carry
out the following procedure to re-set the
sunroof and resume operation:
1. Switch the ignition ON.
2. Press and hold the front of the SLIDE
switch with the sunroof closed
completely. The sunroof lowers slightly
and returns to its original position
when the re-setting is finished.
NOTE
Re-set cannot be performed with the
sunroof open. Close the sunroof
completely before re-setting.
Knowing Your Mazda
Doors and Locks
3-33
Mazda5_8DF6-EI-13J_Edition7 Page105
Thursday, March 9 2017 8:34 PM
Form No.8DF6-EI-13J