Mazda CX-5, Manual

Page: 255 / 840

Auto-wiper control *
When the wiper lever is in the
position, the rain sensor senses the amount
of rainfall on the windscreen and turns the
wipers on or off automatically
(off
― intermittent ― low speed ― high
speed).
The sensitivity of the rain sensor can be
adjusted by turning the switch on the
wiper lever.
From the centre position (normal), rotate
the switch upward for higher sensitivity
(faster response) or rotate it downward for
less sensitivity (slower response).
Higher sensitivity
Less sensitivity
Switch
Centre
position
CAUTION

Do not shade the rain sensor by adhering
a sticker or a label on the windscreen.
Otherwise the rain sensor will not
operate correctly.

When the wiper lever is in the
position and the ignition is switched ON,
the wipers may move automatically in
the following cases:

If the windscreen above the rain sensor
is touched or wiped with a cloth.

If the windscreen is struck with a hand
or other object from either outside or
inside the vehicle.
Keep hands and scrapers clear of the
windscreen when the wiper lever is in the
position and the ignition is
switched ON as fingers could be pinched
or the wipers and wiper blades damaged
when the wipers activate automatically.
If you are going to clean the windscreen,
be sure the wipers are turned off
completely (when it is most likely that the
engine is left running) this is particularly
important when clearing ice and snow.
NOTE

Switching the auto-wiper lever from the
to the position while driving
activates the windscreen wipers once,
after which they operate according to
the rainfall amount.

The auto-wiper control may not operate
when the rain sensor temperature is
about –10 °C (14 °F) or lower, or about
85 °C (185 °F) or higher.

If the windscreen is coated with water
repellent, the rain sensor may not be
able to sense the amount of rainfall
correctly and auto-wiper control may
not operate properly.
When Driving
Switches and Controls
*Some models.
4-97
CX-5_8HD5-EE-18K_Edition2 2018-11-22 13:14:48