Fig. 81: Removing Rear Spoiler (BP With TC)
Courtesy of MAZDA MOTORS CORP.
REAR SPOILER INSTALLATION (BP WITH TC)
1. If installing a new rear spoiler, perform the following procedure:
1. Using a cutter, remove any remaining double-sided tape from the trunk lid.
2. Remove any grease or dirt from the trunk lid affixing surface.
2. If reusing the rear spoiler, perform the following procedure:
1. Using a cutter, remove any remaining double-sided tape from the rear spoiler and trunk lid.
2. Remove any grease or dirt from the rear spoiler and trunk lid affixing surfaces.
3. Affix double-sided adhesive tape to the rear spoiler as shown in the figure.
3. Peel back the tape backing
approx.3 cm
from each end and fold towards the exposed surface of the rear
spoiler.
WARNING:
Using a cutter with bare hands can cause injury. Always wear gloves
when using a cutter.
NOTE:
If installing a new rear spoiler, double-sided adhesive tape is already
affixed to the spoiler.
2005 Mazda MX-5 Miata
2005 ACCESSORIES & EQUIPMENT Exterior Trim - MX-5 Miata
Microsoft
Saturday, July 04, 2009 12:04:29 PM
Page 79
© 2005 Mitchell Repair Information Company, LLC.
