MAYBACH COMAND AND REAR-CABIN AUDIOVISUAL SYSTEM, Operator'S Manual

Page: 129 / 319

129
Navigation – Front Cabin
Destination input
1 “Hours” longitude value
2 “Minutes” longitude value
3 “Seconds” longitude value
4 “Seconds” latitude value
5 “Minutes” latitude value
6
“Hours” latitude value
Press

or

to select the value you
wish to set.
Select the desired value using

or

.
Keep repeating the last two steps un-
til you have set the required longi-
tude and latitude.
Press

.
If the coordinates entered are located
in the digital map range, the display
will switch to map display with cur-
sor. The center point of the cursor in-
dicates the position of the
coordinates entered on the map.
Press

.
The Start Route Guidance menu ap-
pears.
Press

.
Route calculation begins.
You can store the current vehicle posi-
tion or a location selected via the map as
an entry in the
Last Destinations
memory.
Therein such entries are marked with
(
page 150).
If you wish to store such entries for later
retrieval or repeat usage, you can save
them in the standard destination memo-
ry (
page 151).
Storing current vehicle position
Press

.
Press any soft key if the soft key dis-
plays are hidden.
The soft key displays appear.
i
Route guidance is only possible to co-
ordinates within the digital map
range.
Storing map location