MAYAH FLASHMAN II, Operating Manual

Page: 19 / 91

First Start > Useful Hints
19
© 2012 MAYAH Communications
Operating Manual for FLASHMAN II
·
Installation. The new firmware is installed automatically. The
progress is shown by the text messages at the LCD screen and/
or blinking of LEDs. After this step is completed successfully
another reboot will occur automatically.
·
First start of the new firmware. At this point some further
update processes might occur without notice. These processes
must not be interrupted.
·
Update process is finished when the
Start Screen is displayed.
2.7.5 How to activate Keycodes
Keycodes are used to activate optional algorithms (see also Codec/Setup/Quality
) and functions of FLASHMAN II. Keycodes are provided by MAYAH
Communications.
Keycodes can be set for each particular device by using Web Remote (menu
item "SPECIAL/Keycodes").
Alternatively keycodes can be entered with the direct command 'sys_keycode
<keycode>' by using Telnet session, boot script (see below) or any other control
type.
2.7.6 How to reset the device
This operation should only be done by expert users. MAYAH is not
responsible for any possible risks or configuration losses in case of
misuse of this function.
Upon factory reset the entire configuration of the device will be set
back to the factory default values. Codec quality profiles, phone book
entries and all presets created by device users will be deleted!
There are several ways to bring the FLASHMAN II back to the factory defaults
a) it is possible to do in the menu
SYSTEM/MISC/Factory Default .
b) it is possible to do in the menu SPECIAL/Reset of the Web Remote Control.
c) it is possible to do by establishing a telnet session to the FLASHMAN II or by
using a telnet console in the SPECIAL area of the integrated web-remote and
typing the direct command 'sys_reset factory'.
d) it is possible to include the direct command 'sys_reset factory' in the Boot
Script file and apply the boot script as described in the next chapter of this
manual.