![background image](http://html1.mh-extra.com/html/maxwell/mw-3051-bn/mw-3051-bn_manual-instruction_1746416009.webp)
9
ENGLISH
•
This unit is not intended for usage by chil-
dren. Place the unit out of reach of children
during operation and cooling down.
•
The unit is not intended for usage by physi-
cally or mentally disabled persons (including
children) or by persons lacking experience or
knowledge if they are not under supervision
of a person who is responsible for their safety
or if they are not instructed by this person on
the usage of the unit.
•
Do not use the unit if the power cord or the
plug is damaged, if the unit works improp-
erly or after it was dropped or in case of
leakage.
•
Do not attempt to repair the unit. Do not dis-
assemble the unit by yourself, if any mal-
function is detected or after it was dropped,
unplug the unit and apply to any authorized
service center from the contact address list
given in the warranty certificate and on the
website www.maxwell-products.ru.
•
Transport the unit in the original package
only.
•
Keep the unit out of reach of children and dis-
abled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY, ITS COMMERCIAL USAGE AND USAGE
IN PRODUCTION AREAS AND WORK SPACES IS
PROHIBITED.
BEFORE THE FIRST USE
After unit transportation or storage at low tem-
perature keep it for at least three hours at room
temperature before switching on
.
•
Unpack the iron; remove the protection from
the soleplate (13), if any.
•
Check the unit for damages, do not use the
iron in case of damages.
•
Before switching the iron on, make sure that
your home mains voltage corresponds to the
iron operating voltage.
•
There may be water residue in the tank, this
is normal, as the iron has undergone factory
quality control.
Note
: While the first switching on the heating
element of the iron burns, therefore occurrence
of foreign smell and a small amount of smoke is
possible, it is normal.
Control knobs, indications and symbols
•
The continuous steam supply knob (3) has
3 fixed positions:
–
– steam supply is off;
–
– steam supply is on;
–
– «double steam»
and one unfixed position:
–
– self-clean.
•
Burst of steam button (4) – press the button to
activate the additional steam supply function.
•
Water spray button (5) – press the button to
activate the water spray function.
•
Heating element ON/OFF indicator (7) –
when the indicator lights up, the iron sole-
plate is heating up.
•
Temperature control knob (11) – allows to
set the iron soleplate temperature depend-
ing on the type of fabric (see the table
below). The knob is in the position «OFF» –
the iron is off.
•
«MAX» maximal water level mark
•
The symbol
indicates hot surfaces.
WATER SELECTION
You can use tap water to fill the water tank (10).
If tap water is hard, use distilled or demineralized
water, this will prolong service life of the iron.
Note:
Do not fill the water tank (10) with scent-
ed liquids, vinegar, starch solution, descaling
reagents, chemical agents etc.
FILLING THE WATER TANK
Before filling the iron with water, make sure that
it is unplugged.
•
Set the temperature control knob (11) to the
position «OFF», and the continuous steam
supply knob (3) to the position
– continu-
ous steam supply is off.
•
Open the water inlet lid (2).
•
Pour water into the water tank (10) and then
close the lid (2) tightly.
Note:
•
Do not exceed the «
MAX
» mark (12).
•
If you need to refill water during ironing,
always switch the iron off first and unplug it.
•
After you finish ironing, switch the iron off,
wait until it cools down completely, then open
the water inlet lid (2), turn over the iron and
drain the remaining water.
IM MW-3051.indd 9
10/4/17 11:45