Maxwell MW-3035 VT, Manual Instruction

Page: 13 / 54

ENGLISH
13
•
Turn the temperature control knob (10) to
set the required ironing temperature: “•”,
“••”, “•••” or “MAX”, depending on the
type of fabric, the pilot lamp (7) will light up.
•
Once the soleplate (14) reaches the set
temperature, the pilot lamp (7) will go out
and you can start ironing.
DRY IRONING
•
Set the continuous steam supply knob (3)
to the position « » (steam supply is off).
•
Place the iron on its base (9).
•
Insert the power plug into the mains
socket.
•
Turn the temperature control knob (10) to
set the required ironing temperature: “•”,
“••”, “•••” or “MAX”, depending on the
type of fabric, the pilot lamp (7) will light up.
•
Once the soleplate (14) reaches the set
temperature, the pilot lamp (7) will go out
and you can start ironing.
•
After you finish ironing, set the temperature
control knob to the “MIN” position.
•
Pull the power plug out of the mains socket
and let the iron cool down completely.
STEAM IRONING
•
Place the iron on its base (9).
•
Insert the power plug into the mains sock-
et.
•
Make sure that there is enough water in the
water tank (12).
•
Turn the temperature control knob (10) to
set the required ironing temperature: in the
steam operation zone or «MAX» (•••), the
pilot lamp (7) will light up.
•
Once the soleplate (14) reaches the set
temperature, the pilot lamp (7) will go out
and you can start ironing.
•
Turn the continuous steam supply knob
(3) to set the steam generation rate, steam
will start going out from the soleplate (14)
openings.
•
After you finish ironing, set the temperature
control knob (10) to the “MIN” position, and
the continuous steam supply knob (3) to
the position « » (steam supply is off).
•
Pull the power plug out of the mains socket
and let the iron cool down completely.
Attention! If steam is not supplied constantly
during the operation, check whether the steam
supply knob (3) is set properly and whether
there is water in the water tank.
BURST OF STEAM
Burst of steam function is useful when ironing
folds and can only be used at high ironing
temperatures (when the temperature control
knob (10) is set to «•••» or «MAX»).
When the burst of steam button (4) is pressed,
steam will go out of the soleplate.
Note:
•
To avoid water leakage from steam
openings, press the burst of steam but-
ton (4) with a 4-5 sec. interval.
VERTICAL STEAM
Vertical steam function can be used only at
high ironing temperatures (that is, when the
temperature control knob (10) is set to «•••»
or “MAX”).
Hold the iron vertically at the distance of 15-30
cm from the clothes, press the burst of steam
button (4) with a 4-5 seconds interval, steam
will be supplied from the soleplate (14).
WATER SPRAY
•
You can dampen the fabric by pressing the
water spray button (5) several times.
•
Make sure that there is enough water in the
water tank (12).
IMPORTANT INFORMATION
•
Vertical steam is not recommended for
synthetic fabrics.
•
To avoid fabric burning, do not touch it with
iron soleplate while steaming.
•
Never steam clothes on a person, as the
steam temperature is very high, use a
clothes hanger or a stand.
STEAM CHAMBER CLEANING
To prolong service life of the iron, we
recommend to clean the steam chamber
regularly, especially in regions with hard tap
water.
MW-3035.indd 13 18.11.2013 16:17:41