Shenzhen Maxtang Computer Co., Ltd
12
Two
-
in
-
one headphone jack
:
JAUD
(Screen Printing: JAUD)
Pin
Signal
1
L+
2
L
-
3
R
-
4
R+
2.14 Hardware Auto Start
(Screen Printing: JAT)
JAT
(Screen Printing: JAT)
Setting
JAT
Close
Hardware Auto Start
Please note that this jumper’s function is similar to the BIOS’s “State After G3” function. When the latter
is set to “S0 State”, the device will start automatically after being connected to power.
2.15 CMOS Clearance/Retention
(Screen Printing: CLR_CMOS)
CMOS is powered by onboard button batteries. Clearing CMOS will permanently remove the previous
system settings and restore the board system to original settings (factory settings).
Step 1:
Turn off the PC and disconnect the power adapter.
Step 2:
Press CLR_CMOS for 10 seconds then disconnect.
Step 3:
Restart the device, press the <DEL> button to enter the BIOS, load the optimal default value,
save, and exit the settings.
CMOS
(Screen Printing:
CLR_CMOS)
Setting
CLR_CMOS
Close
Clear CMOS
Please do not clear COMS when the PC is connected to power in case board damages.