Maxsine EP3E Series, User Manual

Page: 19 / 40

1.5 Servo motor installation
9
>50mm >50mm
>
1
0
0
m
m
>
1
0
0
m
m
>100mm
通风气流方向
X3
X1
X2
X3
X1
X2
X3
X1
X2
1.5
Servo motor installation
1.5.1
The environmental conditions for installation

Ambient temperature: 0 to 40
℃
; Ambient humidity: less than 80 %( no dew).

Storage temperature: -40 to 50
℃
; Storage humidity: less than 93 %( no dew).

Vibration: less than 0.5G.

Install the servomotor in well-ventilated place with less moisture and a few dusts.

Install the servomotor in a place without corrosive liquid, flammable gas, oil vapor, cutting
cooling liquid, cutting chips, iron powder and so on.

Install the servomotor in a place without water vapor and direct sunlight.
1.5.2
The method of installation

For horizontal installation: In order to prevent water, oil, etc. from entering inside of the
servomotor, please put the cable connector downward.

For vertical installation: if the shaft of the servo motor is in upward direction with a speed
reducer, some prevention measure shall be taken against entering inside of the servomotor by
oil come from the speed reducer.

Motor shaft extension should be long enough, or may cause vibration while motor is in
running

In case of installation or removing the servomotor, please do not hit the servomotor with a
hammer, otherwise the shaft and the encoder can be damaged.