MaxPac Single/Dual/Triple-Screen 8230 Training and Maintenance Guide
83
Figure 5-67
4) Gently grasp the drive in question and pull it out of the magazine (Figure 5-67).
Note:
These disks are hot-swappable, so you can replace individual drives while the magazine remains
resident in the system. When the upper binding bar is removed the 4 slots in the main drive cage may
slide back. Make sure that when replacing the upper binding bar that the tabs go into these slots.
Note:
In order to easily identify these disks, MaxVision serial numbers are affixed to the bottom edge
(the small white strips shown toward the bottom of the drives in Figure 5-67). Recording the positions
and serial numbers of your disks for each MaxPac is advisable.
Optical Drive (CD/DVD)
1) Note that it is not necessary to open the display assembly into its service position in order to
perform this procedure.
2) Undo the two knurled attaching the CD/DVD drive to the outside of the system's main chassis
(Figure 5-68).
Figure 5-68
Figure 5-69
3) Gently remove the CD/DVD drive from the system (Figure 5-69).
4) Take the new CD/DVD assembly as supplied by MaxVision support and incorporate it into the
system by performing the steps described above in reverse order.
Summary of Contents for Dual-Screen 8230
Page 6: ......