72
MaxPac Single/Dual/Triple-Screen 8230 Training and Maintenance Guide
Opening the Display Assembly into its Service Position
In order to replace and/or upgrade modules inside the MaxPac system, it is necessary to open the
display assembly into its service position as discussed below.
1) Lay the system flat on the table on top of a piece of firm, non-abrasive foam (or similar material)
capable of supporting the system's weight as shown in Figure 5-26. Observe that the displays
should be in the closed position and facing upwards.
Figure 5-26
Figure 5-27
2) Use a Phillips #2 screwdriver to remove the two 10-32 1/4" black countersunk screws – one on
each site (on the top-side of the system close to the handles) – holding the screen assembly to
the chassis (Figure 5-27).
3) Use a Phillips #2 screwdriver to remove the two 10-32 silver truss head screws on the top of the
system (Figure 5-28).
Figure 5-28
Figure 5-29
4) Press the feet down into their fully "tilted" position as shown in Figure 5-29 (this is necessary to
allow the display assembly to fully hinge up).
5) Walk around to the other side of the system (so you are facing the bottom of the system) and lift
the screen assembly as shown in Figure 5-30.
6) Squeeze the integrated support stands together as illustrated in Figure 5-30.
Summary of Contents for Dual-Screen 8230
Page 6: ......
