Maintenance
Care & Maintenance
maxon BIKE
DRIVE
| User Manual | rel8583
15
• The amber battery charger LED indicates that the battery charger is connected to
the battery. The LED lights up for the entire duration and after completion of the
charging process.
• The battery charger’s fan may automatically switch on and off during charging.
• If no battery is connected to the charger, the red battery charger LED lights up.
6)
Store battery in a cool dry place.
For example, do not let the battery
in your car when it is exposed to direct sunlight since it can get
extremely hot in a very short time! Also, observe the permitted envi-
ronmental conditions (
2.1.2 Storage of the Battery
Store the battery in a cool, dry place. For information on the maximum permit-
ted storage temperature see
Long-term
storage
If you are not using the battery for extended periods, store it at approximately
60% of its capacity. A permanently higher charge will accelerate the principle-
related natural aging of the battery.
2.1.3 Periodic Inspection
In addition to the maintenance specified by the bike manufacturer, you or your
authorized BIKE
DRIVE
dealer must perform the following inspections.
Table 2
Maintenance plan
When?
What?
After heavy use
Brakes:
Check wear on brake discs and brake pads,
replace if necessary
Every 200 km
or
at least annually
•
Rear wheel:
Check on specified spoke tension
•
Quick-release axle:
Check for firm fit
•
Screw connections:
Check for firm fit
•
Plug connections:
Check for firm fit
Every 1000 km
or
at least annually
Battery rail:
Check for firm fit
When not in use or
for storage:
Every 6 months
Battery:
Charge battery to approximately 60% (this
corresponds to approximately 3 of 5 battery LEDs).
Periodically check the charge and recharge to 60%, if
necessary.
